TM 9-2320-209-20-3-1 d. Adjustment. FRAME 1 1. Using 1/2-inch wrench, loosen locknut (1) and screw adjusting bolt (2) all the way in as shown. 2. Using C-clamp, compress switch return spring (3) to close starter switch (4) as shown. CAUTION In step 3 do not pull lever any further forward than shown. This could damage spring inside of starter. 3. Move lever (5) 4. Move lever (5) out binding. forward in direction shown, until it is almost vertical. back and forth a few times. The lever should move freely with- NOTE If lever does not move freely, take out starter and tell direct support maintenance. Refer to para 7-10. GO TO FRAME 2 7-44