TM 9-2320-209-20-3-1 7-4. ALTERNATOR AND PULLEY REMOVAL TOOLS: Flat-tip screwdriver 0.005-inch feeler gage 7/16-inch socket wrench Torque wrench, 150 pound-feet capacity Torque wrench, 200 pound-inches capacity SUPPLIES: Solvent, dry cleaning, type Silicone dielectric compound, AND REPLACEMENT. Mechanical puller Strap wrench 3/4-inch wrench 1/2-inch wrench 5/8-inch wrench 15/16-inch wrench 9/16-inch wrench II (SD-2), Fed. Spec P-D-680 MIL-S-8660B PERSONNEL: One EQUIPMENT CONDITION: Truck parked, engine off, handbrake set. a. Preliminary Procedures. (1) Disconnect battery ground cable. Refer to para 7-58. (2) Open hood and right side panel. Refer to TM 9-2320-209-10. b. Removal. FRAME 1 NOTE Cover mounting screws (1) may be at the rear of cover on some alternators. 1. Using screwdriver, unscrew and take out two screws and lockwashers (1). 2. Lift off terminal cover (2). 3. Using screwdriver, unscrew and take out two screws and lockwashers (3). 4. Take off hold down clamp (4). GO TO FRAME 2 7-14