TM 9-2320-209-20-3-1 c. Replacement. WARNING Dry cleaning solvent is flammable. DO not use near open flame. Keep a fire extinguisher nearby when working with solvent. to do this will to equipment. Use only result in in well-ventilated area. Failure injury to personnel and damage NOTE Before installing water pump, clean pump using solvent. Make sure that all surfaces contacting gaskets or hose are smooth and free of dirt. 1. Place water pump (1) on front of engine block as shown. 2. Put three bolts with lockwashers (2) through water pump mounting holes and using 9/16–inch wrench, tighten bolts. 3. Put hose (3) on water pump ( 1). Slide clamp (4) into place. Using screw- driver, tighten clamp. 4. Slide hose (5) down from thermostat housing (6) over water pump (1) outlet as shown. 5. Put clamps (7) near ends of hose (5) as shown. Using screwdriver, tighten two screws (8). GO TO FRAME 2 TA 047015 6-40