TM 9-2320-209-20-3-1 6-5. HOSES AND CLAMPS REMOVAL TOOLS : Flat-tip screwdriver 9/16-inch wrench (2) SUPPLIES : Gasket PERSONNEL: One AND REPLACEMENT. 1/2-inch socket wrench 10-inch extension EQUIPMENT CONDITION: Truck parked, engine off, handbrake set. a. Cooling System Hoses and Clamps. (1) Preliminary procedures. (a) Drain cooling system. Refer to para 6-10. (b) Take off generator belts. Refer to para 6-9. (2) Removal. 1. Using screwdriver, loosen two screws (1). 2. Slide two clamps (2) down on hose (3). 3. Using 9/16-inch wrenches, unscrew and take off locknut (4). 4. Pull bolt (5) out of rod end clevis (6). 5. Pull radiator (7) forward at top, just enough to take off hose (3). 6. Pull hose (3) off. Take clamps (2) off hose. GO TO FRAME 2 TA 101584 6-20