TM 9-2320-209-20-3-1 1. Put cable clamp (1) with cable (2) on bypass valve (3). 2. Aline holes and put in capscrew (4) and screw on locknut (5). 3. Put end of cable (2) 1/2 inch through hole in lever (6) and using screwdriver, tighten screw (7). Using pliers, bend cable end at 45° angle. 4. While holding lever (6) towards back of truck, slide cable case (2) in clamp (1) until there is no slack between clamp and lever. 5. Using 7/16-inch wrenches, tighten locknut (5) and cap screw (4). GO TO FRAME 7 TA 080717 5-35