TM 9-2320-209-20-3-1 c. Repair. Repair engine stop control and linkage by replacing damaged or worn parts. d. Replacement. 1. Put grommet (1) in hole in firewall (2). 2. Put end of control cable (3) through hole in instrument panel (4). 3. Put lockwasher (5) and nut (6) on end of control cable (3) and slide them up control cable to back of instrument panel (4). 4. Put end of control cable (3) through grommet (1) and push control assembly (7) into place as shown. 5. Using 9/16-inch wrench, screw on and tighten nut (6) with lockwasher (5) . GO TO FRAME 2 TA 047398 4-177