TM 9-2320-209-20-3-1 e. Adjustment. FRAME 1 1. Using l/2-inch wrench, unscrew and take off locknut (1) from threaded stud on ball joint (2). 2. Take ball joint (2) out of lever assembly (3). 3. Using 1/2-inch wrench, loosen nut (4). 4. Shorten rod (5) by screwing ball joint (2) onto rod. 5. Lengthen rod (5) by unscrewing ball joint (2). 6. When length of rod (5) is correct, threaded stud on ball joint (2) will slide into lever assembly (3) freely. Put threaded stud of ball joint (2) through hole in lever assembly (3) and using 1/2-inch wrench, tighten nut (4). 7. Using 1/2-inch wrench, screw locknut (1) on threaded stud of ball joint (2). END OF TASK TA 047152 4-174