TM 9-2320-209-20-3-1 FRAME 5 1. Put hand throttle control wire (I) through clip (2). Slide coupling (3) on end of throttle control wire and up to clip. 2. Place coupling (3) 1/8 inch away from clip (2) and tighten screw (4) using phillips screwdriver. 3. Move control rod (5) forward and to rear several times to check operation of control linkages. Make sure linkages move freely. NOTE Follow-on Maintenance Close hood and left side panel. END OF TASK Action Required: Refer to TM 9-2320-209-10. TA 047151 4-173