TM 9-2320-209-20-3-1 Section VI. ACCELERATOR, THROTTLE, AND ENGINE STOP CONTROLS 4-28. THROTTLE CONTROL AND LINKAGE REMOVAL, REPAIR, REPLACEMENT, AND ADJUSTMENT. TOOLS : 9/16-inch open end wrench (2) Cross-tip screwdriver (Phillips type) 6-inch scale SUPPLIES: None PERSONNEL: TWO EQUIPMENT CONDITION: Truck parked, engine off, handbrake set. a. Preliminary Procedure. Open hood and right side panel. Refer to TM 9-2320-209-10. b. Removal. FRAME 1 1. Using screwdriver, loosen screw (1) and slide connector (2) off throttle control wire (3) . GO TO FRAME 2 TA 047385 4-157