TM 9-2320-209-20-3-1 c. Replacement. 1. 2. 3. 4. 5. Slide two clamps (1) on ignition unit (2). Put ignition unit (2) with two clamps (1) in place and aline screw holes. Using 1/2-inch wrench, screw on and tighten two screws with washers ( 3). Using pliers, screw on and tighten electrical cable connector (4) to ignition unit (2). Using 7/8-inch wrench, screw on and tighten electrical cable connector (5) to ignition unit ( 2). NOTE Follow-on Maintenance Action Required: 1. Close hood. Refer to TM 9-2320-209-10. 2. Reconnect battery ground cable. Refer to para 7-58. END OF TASK TA 083343 4-74