TM-9-2320-209-20-2-2 Troubleshooting Part 2 for M44A1 and M44A2 Series Trucks
Page 449 of 745
TM 9-2320-209-20-2-2 ● Put back cable that has come off of discharge valve ● ● ● ● ● Make sure valve and control levers are in OFF positions. Refer to TM 9-2320-209-10 Using 1/2-inch wrench loosen two nuts on U-bolt Slide cable end through U-bolt and using pliers hold end tightly Tighten two nuts on U-bolt using 1/2-inch wrench Adjust cables. Refer to Vol 3, chapter 18, para 18-25 or 18-27 • Put back cable that has come off control lever ● ● ● ● ● Make sure valve and control lever are in OFF positions. Refer to TM 9-2320-209-10 Using 5/8-inch wrench loosen nut Slide cable end through clamp bolt and using pliers hold end tightly Tighten nut using 5/8-inch wrench Adjust cables. Refer to Vol 3, chapter 18, para 18-25 or 18-27 Ž Replace broken discharge valve control cable ● Refer to Vol 3, chapter 18, para 18-25 or 18-27 Figure 65-5 (Sheet 2 of 3) TA 114978 65-17