TM 9-2320-209-10-4 Section V. WINCH EQUIPMENT ITEMS MAINTENANCE 2-10. FRONT WINCH SHEAR PIN REMOVAL AND REPLACEMENT. TOOLS: l/4-inch drift punch Ballpeen hammer, light Pliers SUPPLIES: Artillery and automotive grease, type GAA, MIL-G-10924 Cotter pin (2) PERSONNEL: One EQUIPMENT CONDITION: Truck parked, engine off, handbrake set. a. Removal. FRAME 1 1. Working under front left side of truck, find universal joint (1). 2. Turn universal joint (1) on winch drive shaft (2) until shear pin (3) can be seen. 3. Using pliers, take out two cotter pins (4), one on each end of shear pin (3). GO TO FRAME 2 2-35