TM 9-2320-209-10-4 Section III. WHEELS EQUIPMENT ITEMS MAINTENANCE 2-5. JACKING PROCEDURE. NOTE This task is the same for all wheels. This task is shown for the left rear-rear wheel. TOOLS : Hydraulic screw jack with handle SUPPLIES : Wood block PERSONNEL: One EQUIPMENT CONDITION : Truck parked, engine off, handbrake set, wheels choked. FRAME 2 1. Take hydraulic screw jack (1) and handle (2) out of stowage compartment above left running board. 2. Put wood block (3) on ground under axle housing (4) and put screw jack (1) on wood block . 3. Turn out screw jack (1) until it touches axle housing (4). 4. Using slotted end of jack handle (2), turn bleeder valve (5) to the right. Put jack handle in screw jack (1). 5. Moving jack handle (2) up and down, raise wheel assembly (6) off ground. END OF TASK 2-14