TM 9-2320 -209-10-1 a. Before Engine Startup. FRAME 1 1. Pull handbrake lever (1) up to position. NOTE The handbrake must click into place when handbrake lever (1) is being pulled up. If you do not hear a click adjust handbrake as given in steps 2 through 5. 2. Push handbrake lever (1) forward to off position. 3. If the handbrake is loose (not enough tension) turn knob (2) to the right one turns. If the handbrake is tight (too much tension) turn knob (2) to the left two turns. 4. Pull handbrake lever (1) up again. or two one or 5. If handbrake clicks into place it is properly adjusted. If click is not heard, do steps 2, 3 and 4 again until handbrake clicks into place. 6. If handbrake cannot be properly adjusted tell organizational maintenance. 7. Set FRONT TRANSMISSION gearshift lever (3) to N position. GO TO FRAME 2 4-30