TM 9-2320-209-10-1 Table 2-3. Operating Dimensions Wheel Departure Turning Radius Truck Type Base (in. ) Angle (deg) W/WN WO/WN (ft) Cargo M35 type 154 40 37 ft 6 in. 36 Cargo M36 type 190 24 46 ft 45 Fuel tank 154 40 37 ft 6 in. 36 Water tank 154 40 37 ft 6 in. 36 Shop van 154 40 37 ft 6 in. 36 Repair shop 154 40 37 ft 6 in. 36 Tractor 142 73 36 ft 35 Dump 154 70 37 ft 6 in. 36 Pipeline construction 154 40 37 ft 6 in. 36 Earthboring and polesetter 154 40 37 ft 6 in. 36 Note: The approach angle for all trucks covered in this manual is 40 degrees with winch and 47 degrees without winch. Table 2-4. Capacities Description Capacity Truck(s) Cooling system All trucks LDS427-2 34 qt LD-465 & LDT465 28-32 qt Crankcase 22 qt All trucks Differentials (each) 6 qt All trucks Fuel tank 50 gal All trucks Transmission 1. W/PTO 10-1/2 pt All trucks Transmission 2. WO/PTO 8-1/2 pt All trucks Transfer 7 qt All trucks Front winch worm housing 1-1/4 pt All trucks equipped with front winch Front winch end bearing frame 1 pt All trucks equipped with front winch Rear winch worm housing 7 pt M764 Power divider 3-1/2 qt M764 Earth boring machine intermediate case 5 qt M764 Earth boring machine clutch and brake case 5 qt M764 Earth boring machine boring case 10 qt M764 Outrigger hydraulic system 6 gal M764 Rear winch cable level winder speed reducer housing 1-3/4 pt M764 Rear winch jaw clutch housing 1-3/4 pt M756A2 Rear winch worm gear housing 2-3/4 pt M756A2 2-23