TM 9-2320-209-10-1 FRAME 3 Soldier A 1. 2. Soldier B 3. Soldier A 4. GO TO FRAME 4 Put winch cable loop (1) into square auger mounting hole (2). Put auger-to-holder pin (3) into hole in auger (4), through loop (1) and into other side of hole in auger. CAUTION Never move winch control lever to off position when there is a load on winch. This will cause the load to drop. Be sure that winch cable does not bind against derrick sheave cover while lifting auger and moving auger to rear of truck. Guide auger with a tag line after auger is lifted from body. Operate rear winch. Refer to para 4-15d. Lift auger no higher than necessary to move it to rear of truck. Guide auger with tag line. 4-333