TM 9-2320-209-10-1 FRAME 2 1. Step on and press clutch pedal (1) all the way down. 2. Make sure that FRONT TRANSMISSION gearshift lever (2) is in N position. 3. Place POWER TAKEOFF SHIFTS lever (3) in LOW position. 4. Set handbrake lever (4) off to down position. 5. Let clutch pedal (1) come up slowly. The front winch will pull vehicle forward and wind winch line onto drum. 6. Step on brake pedal (5) and press down lightly to make sure of a tight, neat wind. NOTE Make sure that first layer of winch line goes onto drum in order and that each additional layer starts back across drum. If necessary, use wooden block to push or hammer line closely wrapped. If truck is equipped with a load winding device, this will not be necessary. GO TO FRAME 3 4-73