TM-9-2920-257-30&P Maintenance and Parts Manual for 200 Amp M113 Generator Download
Page 53 of 111
TM 9-2920-257-30&P (d) Press inside seal (10) into seal bore until it is flush with face of anti-drive end housing (9). (e) Turn anti-drive end housing (9) over in arbor press. NOTE Outer seal in anti-drive end housing is to be assembled so that seal lips flare outward, away from rotor. (f) Apply thin film of grease (item4, App B) to lips of outer seal (11). Place outer seal in position on the seal bore of anti-drive end housing (9) with seal lips flaring outward, away from rotor (14). See figure 3-8 for proper seal lip position. (g) Press outer seal (11) into seal bore until it is flush with face of anti-drive end housing (9). (8) Install slideable bushing in anti-drive end housing ear (fig.3-1). (a) Place anti-drive end housing (9) in arbor press so that inner side of anti-drive end housing (side nearest rotor (14)) faces up. Housing ear must be supported. (b) Press slideable bushing (13) into ear on anti-drive end housing (9) until flush. (9) Install anti-drive end housing on drive end housing assembly (fig. 3-1). (a) Slide anti-drive end housing (9) on shaft of rotor (14). (b) Push anti-drive end housing (9) tightly against stator (19) making sure that stator locator pin meshes with matching hole in anti - drive end housing. 3-23