TM-9-2920-257-30&P Maintenance and Parts Manual for 200 Amp M113 Generator Download
Page 50 of 111
TM 9-2920-257-30&P (c) Place roller bearing tool (fig. F-1) on top of roller bearing according to figure 3-11. Press in bearing until it is flush in housing with outer seal shoulder. (5) Install rotor and ball bearing in drive end housing assembly(fig.3-1). (a) Place anti-drive end housing (9), with interior of housing facing up, on a vise with jaws opened approximately 4 inches. (b) Place assembly spacer tool (fig. F-1) in anti-drive end housing (9) so that it is centered around bearing bore. NOTE Assembly spacer tool installed in step (b) above will be removed in step (g) below. (c) Insert short end of shaft of rotor (14) in anti-drive end housing (9). (d) Place stator (19) and drive end housing assembly (21) over rotor (14), and down into place on anti-drive end housing (9). Be sure that stator laminations fit flush in pilot bore of anti-drive end housing and that stator locator pin meshes with matching hole in anti-drive end housing. (e) Place entire assembly in arbor press with drive end housing (21) facing up. Support assembly on hub area of anti-drive end housing (9) around shaft of rotor (14). 3-20