TM-9-2920-257-30&P Maintenance and Parts Manual for 200 Amp M113 Generator Download
Page 47 of 111
TM 9-2920-257-30&P NOTE While applying grease, use finger to form the seal lips of inside seal as shown in figure 3-8. (d) Apply thin film of grease (item 4, App B) tO lipS of inside seal. (3) Install stator to drive end housing assembly (fig. 3-1). NOTE Aline locator pin in drive end housing assembly with matching hole in stator. (a) Place stator (19) in anti-drive end housing (9) so that stator laminations fit flush in pilot bore of anti-drive end housing protect stator windings. (b) Place terminal block insulator (20) onto stator terminal studs so that hex cavities of insulator fit over hex portions of studs. NOTE Aline stator locator pin with matching hole in drive end housing. (c) Place drive end housing assembly (21) over stator (19) so that three stator terminal studs pass through three holes in housing and stator locator pin meshes with matching hole in drive end housing assembly. 3-17 to