TM-9-2920-257-30&P Maintenance and Parts Manual for 200 Amp M113 Generator Download
Page 44 of 111
TM 9-2620-257-30&P d. Generator Repair Procedure. Replace unserviceable parts as required. e. Generator Assembly Procedure. (1) Upon reassembly, all parts disturbed during disassembly, except brushes and brush holder, must be coated with epoxy enamel (item 3, App B). (2) Install inside seal to drive end housing assembly (fig. 3-1). (a) Pack all rectifier leads down inside cavity in drive end housing assembly (21). Place housing in arbor press with rectifiers facing up. CAUTION Bearing will not seat properly if seal is not placed correctly. Place seal on seal bore with seal lips flaring up. (b) Place inside seal (22) in position on seal bore with seal lips flaring up . See figure 3–8 for proper seal lip position. (c) Place ball bearing tool (fig. F-1) on top of inside seal (22) according to figure 3-9. Press in seal flush with bottom of bearing bore. 3-14