TM-9-2920-225-34 Technical Manual for M113 Generator Download
Page 51 of 262
TM 9-2920-225-34 FRAME 2 I 1. 2. 3* 4. 5. Place a piece of l/8-inch thick felt over fan of rotor and fan assembly (1). Place stator (2) over rotor and fan assembly (1) with stator leads facing fan. Place drive end housing (3) up to stator (2). NOTE Have machine shop make fabricated tool. Refer to figure 2-2. Put rotor assembly tool over threaded end of shaft so that large end of tool is against shaft shoulder. Coat shaft journal and inside diameter of lip seal (4) with grease. Place lip seal over tool and onto shaft and take off tool ● With sharp edge of inner race of bearing (5) facing away from rotor (1), press bearing onto shaft of rotor and fan assembly. GO TO FRAME 3 TA103537 2-35