TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 760 of 856
INSTALLATION - Continued NOTE Locate air intake so that engine inducts cool fresh air. Do not overfill any fluid reservoir/tank. If a fluid starts to flow out of reservoir/tank, stop immediately to avoid spillage. Immediately clean up spilled fluid before proceeding with any task. 4. Connect engine cooling system to heat exchanger or radiator similar to vehicle type used to cool engine. Fill cooling system with antifreeze, refer to applicable vehicle lubrication order. 5. Provide an external source of 24 V dc electrical power for starting engine. 6. Install oil pressure gage in oil gallery (Figure 1, Item 1). 1 MAINT_414 Figure 1. Oil Pressure Gage Location. 7. Install water temperature gage in thermostat housing. WARNING Position exhaust piping to carry toxic carbon monoxide exhaust gases away from test area. Failure to comply may result in injury, illness, or death to personnel. 8. Connect tubing to exhaust outlet of turbocharger, or exhaust manifolds, to conduct exhaust gases from engine. 9. Connect throttle control linkage to throttle control levers on governor. END OF TASK ASSEMBLY AND PREPARATION FOR USE NOTE Prime or purge engine fuel system after any major repair or overhaul. 1. Block or disconnect line from fuel pump. TM 9-2815-205-24 0099 0099-2