TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 759 of 856
SUSTAINMENT MAINTENANCE ENGINE PREPARATION FOR RUNNING INITIAL SETUP: Tools and Special Tools Tool Kit, General Mechanic's (WP 0104, Table 1, Item 113) Shield, Turbocharger, Protective (WP 0104, Table 1, Item 89) Materials/Parts Antifreeze (WP 0103, Table 1, Item 3) Oil, Engine (WP 0103, Table 1, Item 27) Oil, Fuel (WP 0103, Table 1, Item 30) References TB 9-2350-368-25 References (cont.) WP 0052 WP 0053 WP 0054 CAUTION Run engine in clean area when air intake ducting is removed. Dirt, dust, and particles in unfiltered air can enter engine and damage parts or cause mechanical failure. INSTALLATION 1. Install engine on dynamometer or powerplant test stand. Refer to TB 9-2350-368-25. WARNING A protective shield must be installed on turbocharger inlet prior to running engine without built-in inlet screen or air cleaners. The turbocharger creates a strong suction at high engine speeds and can pull hands or clothing into spinning blades. Failure to comply may result in injury to personnel. NOTE Do not overfill any fluid reservoir/tank. If a fluid starts to flow out of reservoir/tank, stop immediately to avoid spillage. Immediately clean up spilled fluid before proceeding with any task. 2. Connect source of fuel supply and fuel return to engine. Fill fuel filters with clean grade DF-2 fuel oil. 3. Connect same type of air cleaners used for engine when in vehicle. TM 9-2815-205-24 0099 0099-1