TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 753 of 856
ASSEMBLY - Continued NOTE Use J-7593-15 installer when installing right front or left rear intermediate bearing. Use J-7593-3 installer when installing left front or right rear intermediate bearing. e. Slide installer (Figure 7, Item 38) on end of shaft (Figure 7, Item 33) with large diameter inserted into end of block bore. f. Place spacer (Figure 7, Item 44), thrust bearing (Figure 7, Item 43), flat washer (Figure 7, Item 42), and hex nut (Figure 7, Item 41) over threaded end of shaft (Figure 7, Item 33). g. Align shaft (Figure 7, Item 33) and install C-washer (Figure 7, Item 39) in groove in shaft adjacent to installer (Figure 7, Item 40). h. Place C-washer (Figure 7, Item 37) in groove near end of shaft (Figure 7, Item 33). i. To draw bearing (Figure 7, Item 30) into position, turn hex nut (Figure 7, Item 41) until C-washer (Figure 7, Item 37) butts up against installer (Figure 7, Item 38). j. Remove bearing installer (Figure 7, Item 38) assembly from cylinder block. k. Repeat Steps 1.a.–1.i. for remaining intermediate bearings (Figure 7, Item 30). 62° 62° 37 40 32 BEARING NOTCH ANGLE 39 33 30 41 42 43 44 38 MAINT_409 Figure 7. Cylinder Block Assembly. TM 9-2815-205-24 0098 0098-11