TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 673 of 856
CLEANING WARNING Cleaning solvent is TOXIC and flammable. Wear protective goggles and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and clothes; and do not breathe vapors. Keep away from heat or flame. Never smoke when using cleaning solvent. Failure to comply may result in injury, illness, or death to personnel. Remove all gasket material from end plate and wash plate with cleaning solvent. END OF TASK INSPECTION-ACCEPTANCE AND REJECTION CRITERIA 1. Check plate for nicks, dents, scratches, score marks, and warpage. 2. Inspect screw inserts for cracks and damaged threads. END OF TASK ASSEMBLY If screw inserts (Figure 1, Item 6) were removed, support end plate (Figure 1, Item 3) on flat surface and press screw inserts into plate from front until insert seats on end plate. END OF TASK INSTALLATION 1. Install new gasket (Figure 1, Item 4) on rear of cylinder block using gasket adhesive. 2. Apply a coat of gasket adhesive to outer surface of gasket (Figure 1, Item 4). 3. Align holes in end plate (Figure 1, Item 3) with dowels (Figure 1, Item 5) in cylinder block. Push end plate against cylinder block. 4. Install 10 new lockwashers (Figure 1, Item 2) and 10 screws (Figure 1, Item 1). Torque screws to 30–35 lb-ft (41–47 N·m). 5. On all, except models 5063-5393 and 5063-539L, install special washer (Figure 1, Item 7) and screw (Figure 1, Item 8) on left side of end plate. Torque screw to 71–75 lb-ft (96–102 N·m). END OF TASK TM 9-2815-205-24 0093 0093-3