TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 648 of 856
CLEANING WARNING Cleaning solvent is TOXIC and flammable. Wear protective goggles and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and clothes; and do not breathe vapors. Keep away from heat or flame. Never smoke when using cleaning solvent. Failure to comply may result in injury, illness, or death to personnel. Compressed air used for cleaning purposes will not exceed 30 PSI (207 kPa). Use only with protective equipment (goggles, face shield, gloves, etc.). Failure to comply may result in injury to personnel. Clean front cover with cleaning solvent and dry with compressed air. END OF TASK INSPECTION-ACCEPTANCE AND REJECTION CRITERIA 1. Inspect seals and seal spacers for wear or damage. 2. Inspect pulleys for evidence of cracks, chips, or broken areas. A crack, chip, or broken area on the belt grooves is acceptable provided the damage does not exceed 305 arc and the pulley is installed on the right camshaft. END OF TASK ASSEMBLY 1. Install new oil seals in following manner: NOTE If outside diameter of oil seal is not precoated, coat seal bore in front cover with sealing compound. a. Place inner face of front cover (Figure 3, Item 3) on wooden blocks. b. Place new oil seal (Figure 3, Item 12) on cover (Figure 3, Item 3) with lip of seal pointing toward inner face of cover. Using seal inserter (Figure 3, Item 13), press seal into cover until flush with bottom of counterbore. c. If necessary, remove excess sealing compound from cover and seal. 2. If removed, apply sealing compound to two new expansion plugs (Figure 3, Item 10) and press into front cover (Figure 3, Item 3) until flush with face of bore. TM 9-2815-205-24 0090 0090-4