TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 565 of 856
CLEANING - Continued 2. Injector body cleaning procedures: a. Clean and brush all passages in injector body (Figure 5, Item 23) using injector brush and rack hole brush. b. Ream injector body ring using injection body hand reamer (Figure 5, Item 29). Insert injection body hand reamer in body and turn in clockwise direction a few turns. Then remove injection body hand reamer and check face of ring for injection body hand reamer contact. Repeat operation until injection body hand reamer makes contact with entire face of ring. Clean opposite side of ring in same manner. 3. Injector nut cleaning procedures: a. Turn injection body hand reamer (Figure 5, Item 30) clockwise to remove carbon deposits from lower end of injector nut (Figure 5, Item 6). CAUTION Completely remove all carbon deposits. Carbon deposits on spray tip seating surfaces of injector nut cause poor seating and result in fuel leakage around spray tip. b. Turn injection body hand reamer (Figure 5, Item 31) clockwise to remove carbon deposits from bottom of injector nut (Figure 5, Item 6) to produce a clean uniform seat for spray tip. WARNING Cleaning solvent is TOXIC and flammable. Wear protective goggles and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and clothes; and do not breathe vapors. Keep away from heat or flame. Never smoke when using cleaning solvent. Failure to comply may result in injury, illness, or death to personnel. Compressed air used for cleaning purposes will not exceed 30 PSI (207 kPa). Use only with protective equipment (goggles, face shield, gloves, etc.). Failure to comply may result in injury to personnel. c. Wash injector nut (Figure 5, Item 6) in clean solvent and blow dry. d. If necessary, repeat Steps 3.a.–3.c. until all carbon is removed. 23 29 30 6 31 6 MAINT_279 Figure 5. Injector Body Cleaning. TM 9-2815-205-24 0084 0084-5