TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 477 of 856
ASSEMBLY NOTE Bearing assembly (Figure 2, Item 6) will fit in pulley from either side; however, position bearing assembly on pulley as shown for proper installation. 1. Support pulley (Figure 2, Item 7) and press bearing assembly (Figure 2, Item 6) on pulley with shaft extended upward. Using 1-1/4 inch (3.17 cm) diameter sleeve (Figure 2, Item 8), press outer race of bearing until flush with inside surface of pulley. CAUTION Do not press bearing shaft (Figure 2, Item 2) into bearing assembly (Figure 2, Item 6). Pressure on shaft will distort bearings and destroy bearing assembly. NOTE Pulley and bearing assembly will fit in bracket from either side; however, position pulley and bearing assembly on bracket as shown. 2. Support bracket (Figure 2, Item 4) and press bearing and pulley assembly (Figure 2, Item 9) into bracket using 1/2 inch (1.27 cm) diameter shaft (Figure 2, Item 5). Apply pressure to shaft (Figure 2, Item 2) only. Measure distance (Figure 2, Item A) between outer edge of pulley and bracket using thickness gage. Distance must be 0.160 inch (0.406 cm). 8 5 9 2 A A 4 6 7 MAINT_210 Figure 2. Idler Pulley Assembly. END OF TASK FOLLOW ON TASK Install idler pulley assembly (WP 0013). END OF TASK END OF WORK PACKAGE TM 9-2815-205-24 0076 0076-3/blank