TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download

ASSEMBLY - Continued 2. Right injector control tube assembly a. Install control lever (Figure 3, Item 11) and left-hand helix yield spring (Figure 3, Item 28) on control tube (Figure 3, Item 12) with control lever facing front of control tube. b. Install two of right-hand helix yield springs (Figure 3, Item 27) and control levers (Figure 3, Item 11) on control tube (Figure 3, Item 12) with control lever facing front of control tube. c. Connect curled end of two yield springs (Figure 3, Item 27) and yield spring (Figure 3, Item 28) to three rack control levers (Figure 3, Item 11) and roll yield springs into notch or slots in control tube (Figure 3, Item 12). Turn three adjusting screws (Figure 3, Item 30) with locknuts (Figure 3, Item 29) far enough into slots to position levers on control tube. d. Install return spring (Figure 3, Item 26) and bracket (Figure 3, Item 6) at front of control tube (Figure 3, Item 12). Connect curled end of return spring to rack control lever and extended end of spring behind bracket. 3. Throttle delay assembly a. Install joint (Figure 3, Item 19) and new locknut (Figure 3, Item 17) on piston (Figure 3, Item 18). Tighten nut. b. Install link (Figure 3, Item 16) and new locknut (Figure 3, Item 20) on joint (Figure 3, Item 19). Tighten nut. c. If removed, install screw (Figure 3, Item 24) and new locknut (Figure 3, Item 22) on bracket (Figure 3, Item 21). Tighten nut until width between legs is 1-7/16 inches (36.5 mm). d. Install link (Figure 3, Item 16), two screws (Figure 3, Item 23), two bushings (Figure 3, Item 15), and two new locknuts (Figure 3, Item 14) on bracket (Figure 3, Item 21). Tighten nuts. 1-7/16 in. (36.5 mm) LEFT FRONT SIDE 12 13 17 20 15 14 26 25 16 27 28 29 6 24 30 6 21 22 RIGHT FRONT SIDE THROTTLE DELAY ASSEMBLY 15 14 13 27 23 26 11 27 28 11 11 27 29 30 29 30 11 11 11 29 30 30 30 29 29 18 19 MAINT_198 Figure 3. Injector Control Tube Assembly. END OF TASK TM 9-2815-205-24 0072 0072-5