TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 451 of 856
DISASSEMBLY - Continued b. Loosen locknut (Figure 2, Item 29) and adjusting screw (Figure 2, Item 30) from control lever (Figure 2, Item 11). c. Disconnect yield spring (Figure 2, Items 27 or 28) from each control lever (Figure 2, Item 11). Roll yield springs out of slots and notches of control tube (Figure 2, Items 25 or 12). d. Disconnect return spring (Figure 2, Item 26) from bracket (Figure 2, Item 13) and control lever (Figure 2, Item 11) at rear of left control tube (Figure 2, Item 25) or from bracket (Figure 2, Item 6) and control lever at front of right control tube (Figure 2, Item 12). e. For right control tube assembly, remove bracket (Figure 2, Item 6) from front of tube. f. Slide three control levers (Figure 2, Item 11), two yield springs (Figure 2, Item 27), yield spring (Figure 2, Item 28), and return spring (Figure 2, Item 26) off front of control tube (Figure 2, Items 25 and 12). 2. Throttle delay assembly a. Remove two locknuts (Figure 2, Item 14), two bushings (Figure 2, Item 15), two screws (Figure 2, Item 23), and link (Figure 2, Item 16) from bracket (Figure 2, Item 21). Discard nuts. b. If necessary, remove locknut (Figure 2, Item 22) and machine screw (Figure 2, Item 24) from bracket (Figure 2, Item 21). Discard nut. c. Remove locknut (Figure 2, Item 20) and link (Figure 2, Item 16) from joint (Figure 2, Item 19). Discard nut. d. Remove locknut (Figure 2, Item 17) and joint (Figure 2, Item 19) from piston (Figure 2, Item 18). Discard nut. LEFT FRONT SIDE 12 13 17 20 15 14 26 25 16 27 28 29 6 24 30 6 21 22 RIGHT FRONT SIDE THROTTLE DELAY ASSEMBLY 15 14 13 27 23 26 11 27 28 11 11 27 29 30 29 30 11 11 11 29 30 30 30 29 29 18 19 MAINT_197 Figure 2. Injector Control Tube Disassembly. END OF TASK TM 9-2815-205-24 0072 0072-3