TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 419 of 856
CLEANING WARNING Cleaning solvent is TOXIC and flammable. Wear protective goggles and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and clothes; and do not breathe vapors. Keep away from heat or flame. Never smoke when using cleaning solvent. Failure to comply may result in injury, illness, or death to personnel. Compressed air used for cleaning purposes will not exceed 30 PSI (207 kPa). Use only with protective equipment (goggles, face shield, gloves, etc.). Failure to comply may result in injury to personnel. Wash components with cleaning solvent and dry with compressed air. END OF TASK INSPECTION-ACCEPTANCE AND REJECTION CRITERIA Inspect tubes, brackets, and strainer for cracks or damage. END OF TASK INSTALLATION 1. Install bracket (Figure 1, Item 18), two bolts (Figure 1, Item 8), four flat washers (Figure 1, Item 9), two new lockwashers (Figure 1, Item 17), and two nuts (Figure 1, Item 16) on bracket (Figure 1, Item 10). Do not tighten nuts. 2. Loosely install bracket (Figure 1, Item 10), flat washer (Figure 1, Item 5), new lockwasher (Figure 1, Item 6) and bolt (Figure 1, Item 7) on inlet tube assembly (Figure 1, Item 1). 3. Install strainer (Figure 1, Item 4), two new lockwashers (Figure 1, Item 3), and two bolts (Figure 1, Item 2) on inlet tube assembly (Figure 1, Item 1). Torque bolts to 13–17 lb-ft (18–23 N·m). 4. Install new gasket (Figure 1, Item 19), inlet tube assembly (Figure 1, Item 1), two new lockwashers (Figure 1, Item 20), and two screws (Figure 1, Item 21) on lower front cover (Figure 1, Item 15). Loosely tighten screws. 5. Install two flat washers (Figure 1, Item 13), two new lockwashers (Figure 1, Item 12), and two screws (Figure 1, Item 11) in bracket (Figure 1, Item 18) at main bearing cap (Figure 1, Item 14). Torque screws (Figure 1, Item 11) to 30–35 lb-ft (41–47 N·m) and screws (Figure 1, Item 21) to 13–17 lb-ft (18–23 N·m). 6. Torque bolts (Figure 1, Item 8) to 15–19 lb-ft (20–26 N·m) and bolt (Figure 1, Item 7) to 13–17 lb-ft (18–23 N·m). END OF TASK TM 9-2815-205-24 0065 0065-3