TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 415 of 856
CLEANING WARNING Cleaning solvent is TOXIC and flammable. Wear protective goggles and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and clothes; and do not breathe vapors. Keep away from heat or flame. Never smoke when using cleaning solvent. Failure to comply may result in injury, illness, or death to personnel. Compressed air used for cleaning purposes will not exceed 30 PSI (207 kPa). Use only with protective equipment (goggles, face shield, gloves, etc.). Failure to comply may result in injury to personnel. Wash components with cleaning solvent and dry with compressed air. END OF TASK INSPECTION-ACCEPTANCE AND REJECTION CRITERIA Inspect tubes, brackets, and strainer for cracks or damage. END OF TASK INSTALLATION 1. Install bracket (Figure 1, Item 17), two screws (Figure 1, Item 8), eight flat washers (Figure 1, Item 9), and two new locknuts (Figure 1, Item 16) on bracket (Figure 1, Item 10). Loosely tighten screws. 2. Loosely install bracket (Figure 1, Item 10), two special washers (Figure 1, Item 5), two new lockwashers (Figure 1, Item 6), and two screws (Figure 1, Item 7) on oil pump inlet tube (Figure 1, Item 1). 3. Install strainer (Figure 1, Item 4), two flat washers (Figure 1, Item 3), and two new self-locking bolts (Figure 1, Item 2) on inlet tube (Figure 1, Item 1). Torque bolts to 13–17 lb-ft (18–23 N·m). 4. Install new gasket (Figure 1, Item 18), inlet tube (Figure 1, Item 1), two new lockwashers (Figure 1, Item 19), and two bolts (Figure 1, Item 20) on lower front cover (Figure 1, Item 15). Torque bolts to 13–17 lb-ft (18–23 N·m). 5. Install two special washers (Figure 1, Item 13), two new lockwashers (Figure 1, Item 12), and two screws (Figure 1, Item 11) in bracket (Figure 1, Item 17) at main bearing cap (Figure 1, Item 14). Torque screws to 30–35 lb-ft (41–47 N·m). 6. Torque two screws (Figure 1, Item 8) to 35–39 lb-ft (47–53 N·m) and two screws (Figure 1, Item 7) to 30–35 lb-ft (41–47 N·m), on brackets (Figure 1, Item 17 and 10). END OF TASK TM 9-2815-205-24 0064 0064-3