TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 406 of 856
INSTALLATION - Continued NOTE Model 5063-5299, uses two front blower-to-block bolts which are 5/16 inch longer. These bolts and washers are installed during the igniter and air pump assembly installation. 10. Apply water displacing compound, or equivalent, to four self-locking bolts (Figure 4, Item 4). Install four hardened washers (Figure 4, Item 5) and four self-locking bolts, fastening blower to cylinder block. Finger tighten bolts. 11. Drive dowel pin (Figure 4, Item 10) into cylinder block rear end plate (Figure 4, Item 12). NOTE Final torquing of bolts, attaching blower to block, is done following blower drive support installation (WP 0060). 12. Torque bolts (Figure 4, Item 4) to 10–15 lb-ft (14–20 N·m). 13. Slide two hoses (Figure 4, Item 1) and two clamps (Figure 4, Item 2) onto governor link housing (Figure 4, Item 3) and position between governor and left cylinder head sleeve (Figure 4, Item 24). Slide hoses and clamps onto governor housing and cylinder head sleeve and tighten clamps securely. 14. Slide hose (Figure 4, Item 7) and two clamps (Figure 4, Item 8) onto right cylinder head sleeve (Figure 4, Item 25). Tighten clamps. 1 24 2 3 2 1 5 4 6 12 11 10 7 25 8 24 MAINT_176a Figure 4. Blower Installation. END OF TASK TM 9-2815-205-24 0062 0062-6