TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 402 of 856
REMOVAL 1. Loosen two clamps (Figure 1, Item 2) on two left fuel rod hoses (Figure 1, Item 1) and slide two hoses onto left governor link housing (Figure 1, Item 3). Remove housing, hoses, and clamps from left side. 2. Loosen two clamps (Figure 1, Item 8) on right fuel rod hose (Figure 1, Item 7). Slide hose onto right fuel rod cover (Figure 1, Item 9). 3. Insert punch in flywheel housing hole (Figure 1, Item 11) and drive pin (Figure 1, Item 10) towards blower and clear of rear engine end plate (Figure 1, Item 12). NOTE On model 5063-5299, two blower-to-block bolts and washers were removed during igniter and air pump assembly removal. 4. Remove four self-locking bolts (Figure 1, Item 4) and four hardened washers (Figure 1, Item 5) fastening blower and governor assembly (Figure 1, Item 6) to cylinder block. WARNING Never crawl under equipment when performing maintenance unless equipment is securely blocked. Keep clear of equipment when it is being raised or lowered. Do not allow heavy components to swing while suspended by lifting device. Exercise caution when working near a cable or a chain under tension as equipment may drop or shift. Failure to comply may result in injury to personnel. 5. Using two 3/8-16 eye bolts and multiple leg sling, lift blower and governor assembly (Figure 1, Item 6) from engine. 1 2 3 2 1 5 4 6 12 11 10 9 7 8 MAINT_174 Figure 1. Governor and Blower Mounting Hardware Removal. TM 9-2815-205-24 0062 0062-2