TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 396 of 856
REMOVAL 1. Remove seven screw assemblies (Figure 1, Item 1), governor cover (Figure 1, Item 2), and gasket (Figure 1, Item 3) from governor housing (Figure 1, Item 4). Discard gasket. 2. Remove two bolts (Figure 1, Item 7), two copper flat washers (Figure 1, Item 8), cover (Figure 1, Item 9), and gasket (Figure 1, Item 10) from governor housing (Figure 1, Item 4). Discard gasket and copper flat washers. NOTE Keep spring pack assembly together as a unit and do not disassemble. 3. Using face spanner socket wrench, unscrew packing nut (Figure 1, Item 6) and remove spring pack assembly (Figure 1, Item 5) from side of governor housing (Figure 1, Item 4). 1 9 8 7 2 3 4 6 10 5 MAINT_171 Figure 1. Governor Cover and Throttle Rod Removal. CAUTION Place clean rag over oil drain holes in cylinder head to prevent cotter pin from falling into engine. 4. On right cylinder head, remove cotter pin (Figure 2, Item 12) from pin (Figure 2, Item 14). Remove pin from lower connecting link (Figure 2, Item 15) on injector control tube lever (Figure 2, Item 13). Discard cotter pin. 5. Remove locknut (Figure 2, Item 16) and disconnect lower connecting link (Figure 2, Item 15) from upper connecting link (Figure 2, Item 17). Withdraw lower connecting link. Discard nut. 6. Remove shoulder pin (Figure 2, Item 11) and upper connecting link (Figure 2, Item 17) from inside governor housing (Figure 2, Item 4). TM 9-2815-205-24 0061 0061-2