TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 389 of 856
INSPECTION-ACCEPTANCE and REJECTION CRITERIA 1. Inspect all bearings. Revolve ball bearing slowly by hand and observe rough or tight spots. Replace if this condition exists. Replace bearings if corroded or pitted. 2. Inspect gear teeth for evidence of scoring, pitting, burning, or wear. 3. Examine blower drive support thrust washer for scoring and wear. Thickness of new thrust washer is 0.093 to 0.103 inch (2.36 to 2.62 mm). 4. Inspect serrations on blower drive shaft and governor weight shaft. If excessive backlash is felt when shaft is inserted into mating part, install new shaft. 5. Inspect outside diameter of blower drive gear shaft and mating inside diameter of drive support for scoring and wear. 6. Examine weight carrier, weights, and pins. Replace worn parts. END OF TASK TM 9-2815-205-24 0060 0060-5