TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 388 of 856
DISASSEMBLY - Continued 3. Governor weight shaft and carrier assembly procedures: a. Remove four retaining rings (Figure 3, Item 26) from four weight pins (Figure 3, Item 25). b. Drive four weight pins (Figure 3, Item 25) out of carrier assembly (Figure 3, Item 15) by tapping on punch held against grooved end of pin. Remove two low speed weights (Figure 3, Item 24) and two high speed weights (Figure 3, Item 29). c. Press shaft (Figure 3, Item 12) and governor riser assembly (Figure 3, Item 28) from carrier (Figure 3, Item 27). NOTE Do not remove bearing from riser since it is serviced only as an assembly. d. Slide governor riser assembly (Figure 3, Item 28) from shaft (Figure 3, Item 12). 27 26 25 28 15 29 24 26 12 25 MAINT_167 Figure 3. Governor Weight Shaft Disassembly. END OF TASK CLEANING WARNING Compressed air used for cleaning purposes will not exceed 30 PSI (207 kPa). Use only with protective equipment (goggles, face shield, gloves, etc.). Failure to comply may result in injury to personnel. Wash all parts in fuel oil and dry them with compressed air. END OF TASK TM 9-2815-205-24 0060 0060-4