TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 372 of 856
REMOVAL 1. Scribe lines between air inlet adapter (Figure 1, Item 1), air inlet housing (Figure 1, Item 11), and blower (Figure 1, Item 9) to assure assembly in same location. 2. Remove four screws (Figure 1, Item 2), four lockwashers (Figure 1, Item 3), four flat washers (Figure 1, Item 4), air inlet adapter (Figure 1, Item 1), and gasket (Figure 1, Item 13) from air inlet housing (Figure 1, Item 11). Discard lockwashers (Figure 1, Item 3) and gasket (Figure 1, Item 13). NOTE One air inlet housing to blower screw was removed during removal of fuel line clip. One air inlet housing to blower screw is located inside inlet housing. 3. Remove short screw (Figure 1, Item 5), two long screws (Figure 1, Item 12), two mid-sized screws (Figure 1, Item 8), five lockwashers (Figure 1, Item 6), five flat washers (Figure 1, Item 7), air inlet housing (Figure 1, Item 11), and screen (Figure 1, Item 10) from blower (Figure 1, Item 9). Discard screen (Figure 1, Item 10) and lockwashers (Figure 1, Item 6). 2 3 4 5 6 7 8 6 7 9 11 7 6 12 13 1 10 MAINT_161 Figure 1. Air Inlet Housing Removal/Installation. END OF TASK TM 9-2815-205-24 0056 0056-2