TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 336 of 856
ASSEMBLY - Continued NOTE On models 5063-5393 and 5063-539L, outlet from breather housings point outboard. On model 5063-5392, right breather housing outlet points towards front of engine and left breather housing outlet points towards rear of engine. 3. Install breather retainer (Figure 2, Item 15) and filtering disk (Figure 2, Item 14) in breather housing (Figure 2, Item 1). 4. Install new seal (Figure 2, Item 4), breather housing (Figure 2, Item 1), retainer (Figure 2, Item 13), and three screws (Figure 2, Item 12) in rocker arm cover (Figure 2, Item 9). Torque screws to 48–72 lb-in (5–8 N·m). END OF TASK INSTALLATION NOTE Right and left rocker arm covers are identical except for oil filler hole. Use same procedure to remove both covers. 1. Install new gasket (Figure 2, Item 11) in groove at bottom of rocker arm cover (Figure 2, Item 9). First press gasket into corners and then sides. NOTE On model 5063-5392, oil filler cap is at rear of right rocker arm cover. On models 5063-5393 and 5063-539L, oil filler cap is at front of right rocker arm cover. 2. Install rocker arm cover (Figure 2, Item 9), two resilient mounts (Figure 2, Item 16), two flat washers (Figure 2, Item 17), and two bolts (Figure 2, Item 18) on cylinder head. Torque bolts to 96–156 lb-in (11–18 N·m). 3. On models 5063-5393 and 5063-539L, install hose (Figure 2, Item 3) and clamp (Figure 2, Item 2) on breather housing (Figure 2, Item 1) with hose pointing downward. Tighten clamp. TM 9-2815-205-24 0053 0053-4