TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 335 of 856
DISASSEMBLY - Continued b. If necessary, bend two S-hooks (Figure 1, Item 6) open to disconnect chain (Figure 1, Item 5) from oil filler cap (Figure 1, Item 7) and from strainer element (Figure 1, Item 10). c. If necessary, drive strainer element (Figure 1, Item 10) from rocker arm cover (Figure 1, Item 9). END OF TASK CLEANING WARNING Cleaning solvent is TOXIC and flammable. Wear protective goggles and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and clothes; and do not breathe vapors. Keep away from heat or flame. Never smoke when using cleaning solvent. Failure to comply may result in injury, illness, or death to personnel. Compressed air used for cleaning purposes will not exceed 30 PSI (207 kPa). Use only with protective equipment (goggles, face shield, gloves, etc.). Failure to comply may result in injury to personnel. 1. Clean rocker arm covers and breather housings with cleaning solvent and dry with compressed air. 2. Clean filtering disk with cleaning solvent and dry with compressed air. END OF TASK INSPECTION-ACCEPTANCE and REJECTION CRITERIA Inspect covers for cracks, dents, or other damage. END OF TASK ASSEMBLY 1. On models 5063-5393 and 5063-539L, install oil filler cap (Figure 1, Item 7) as follows: a. If removed, press strainer element (Figure 1, Item 10) into oil filler hole from bottom of rocker arm cover (Figure 1, Item 9) until flush with bottom of bore. Stake strainer element in position. b. If removed, connect chain (Figure 1, Item 5) to oil filler cap (Figure 1, Item 7) and to strainer element (Figure 1, Item 10) with two S-hooks (Figure 1, Item 6). Crimp S-hooks shut. 2. On model 5063-5392, screw oil filler cap (Figure 1, Item 8) into rocker arm cover (Figure 1, Item 9) until cap clicks. TM 9-2815-205-24 0053 0053-3