TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 319 of 856
REMOVAL - Continued 2. Disconnect fuel inlet hose assembly (Figure 2, Item 5) from tee (Figure 2, Item 10) at rear of left cylinder head and from elbow (Figure 1, Item 9) at front of right cylinder head. Remove hose assembly. 5 10 MAINT_149 Figure 2. Fuel Line Removal/Installation. 3. Loosen nuts on two elbows (Figure 1, Item 7) at front of cylinder heads and remove fuel crossover tube (Figure 1, Item 8). END OF TASK INSTALLATION 1. Insert fuel crossover tube (Figure 1, Item 8) into two elbows (Figure 1, Item 7) at front of cylinder heads. Tighten nut on each elbow. 2. Connect fuel inlet hose assembly (Figure 2, Item 5) to elbow (Figure 1, Item 9) at front of right cylinder head and to tee (Figure 2, Item 10) at rear of left cylinder head. Tighten hose connections. 3. If removed, install clip (Figure 1, Item 4) on fuel inlet hose assembly (Figure 1, Item 5). 4. Install clip (Figure 1, Item 4), located on fuel inlet hose assembly (Figure 1, Item 5), flat washer (Figure 1, Item 3), new lockwasher (Figure 1, Item 2), and screw (Figure 1, Item 1) on air inlet housing (Figure 1, Item 6). Torque screw to 16–20 lb-ft (22–27 N·m). END OF TASK FOLLOW ON TASK 1. Install coolant crossover tube (WP 0047). 2. Install air pump support (WP 0042). END OF TASK END OF WORK PACKAGE TM 9-2815-205-24 0049 0049-3/blank