TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 272 of 856
INSTALLATION - Continued 6. Install three ground wires of harness assembly (Figure 6, Item 20), new copper flat washer (Figure 6, Item 36), and bolt (Figure 6, Item 37) in air box heater (Figure 6, Item 11). Torque bolt to 13–17 lb-ft (18–23 N·m). 7. Connect ignition wire (Figure 6, Item 33) to spark igniter (Figure 6, Item 31) and ignition coil (Figure 6, Item 30). 8. If removed, install adapter (Figure 6, Item 35) in air hose (Figure 6, Item 45). Connect hose to check valve (Figure 6, Item 47) and adapter on hose to elbow (Figure 6, Item 34) in air box heater (Figure 6, Item 11). 9. Install terminal of harness assembly (Figure 6, Item 20), clip (Figure 6, Item 25), screw (Figure 6, Item 24), two flat washers (Figure 6, Item 23), new lockwasher (Figure 6, Item 28), and nut (Figure 6, Item 29) to top of angle bracket (Figure 6, Item 27). Torque nut to 30–35 lb-ft (41–47 N·m). 10. If removed, install clip (Figure 6, Item 48) on harness assembly (Figure 6, Item 20). Install screw (Figure 6, Item 46), new lockwasher (Figure 6, Item 49), and nut (Figure 6, Item 50) to bottom of angle bracket (Figure 6, Item 27). Torque nut to 7–9 lb-ft (10–12 N·m). 11. Install wire wrap (Figure 6, Item 38) and clip (Figure 6, Item 42) around harness assembly (Figure 6, Item 20), ignition wire (Figure 6, Item 33), and air hose (Figure 6, Item 45). 12. Install clip (Figure 6, Item 42), flat washer (Figure 6, Item 41), new lockwasher (Figure 6, Item 40), and screw (Figure 6, Item 39) on upper front cover (Figure 6, Item 32). Torque screw to 30–35 lb-ft (41–47 N·m). TM 9-2815-205-24 0043 0043-10