TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 266 of 856
REMOVAL - Continued 9. Remove bolt (Figure 2, Item 37), copper flat washer (Figure 2, Item 36), and grounding wires of harness assembly (Figure 2, Item 20) from air box heater (Figure 2, Item 11). Discard copper flat washer. 10. Remove screw (Figure 2, Item 39), lockwasher (Figure 2, Item 40), flat washer (Figure 2, Item 41), and loop clamp (Figure 2, Item 42) from front cover (Figure 2, Item 32). Discard lockwasher. 11. Disconnect air hose (Figure 2, Item 45) from check valve (Figure 2, Item 47) and adapter (Figure 2, Item 35) from elbow (Figure 2, Item 34) in air box heater (Figure 2, Item 11). If necessary, remove adapter from hose. 12. Disconnect ignition wire (Figure 2, Item 33) from ignition coil (Figure 2, Item 30) and spark igniter (Figure 2, Item 31). 13. Remove two nuts (Figure 2, Items 43 and 44) and disconnect two leads of harness assembly (Figure 2, Item 20) from air pump (Figure 2, Item 26). 14. Disconnect harness assembly (Figure 2, Item 20) from ignition coil (Figure 2, Item 30). 15. Remove nut (Figure 2, Item 50), lockwasher (Figure 2, Item 49), screw (Figure 2, Item 46), and clip (Figure 2, Item 48) from angle bracket (Figure 2, Item 27). Discard lockwasher. If necessary, remove clip from harness assembly (Figure 2, Item 20). 16. Remove nut (Figure 2, Item 29), lockwasher (Figure 2, Item 28), two flat washers (Figure 2, Item 23), screw (Figure 2, Item 24), and clip (Figure 2, Item 25) from angle bracket (Figure 2, Item 27). Discard lockwasher. 17. Remove clip (Figure 2, Item 42) and wire wrap (Figure 2, Item 38) holding harness assembly (Figure 2, Item 20), ignition wire (Figure 2, Item 33), and air hose (Figure 2, Item 45) together. Remove air hose, ignition cable, and harness assembly from engine. TM 9-2815-205-24 0043 0043-4