TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 235 of 856
INSTALLATION 1. Slide two clamps (Figure 1, Item 8) and hose (Figure 1, Item 10) onto elbow (Figure 1, Item 9). 2. Slide two clamps (Figure 1, Item 6) and hose (Figure 1, Item 3) onto air inlet housing (Figure 1, Item 7). 3. On models 5063-5393 and 5063-539L, place new gasket (Figure 1, Item 13) and turbocharger (Figure 1, Item 15) over four studs (Figure 1, Item 12) in exhaust tee (Figure 1, Item 11). Install four special washers (Figure 1, Item 16) and four locknuts (Figure 1, Item 17) on studs. Torque locknuts to 35–39 lb-ft (47–53 N·m). 4. Loosen coupling (Figure 1, Item 1) on compressor housing of turbocharger (Figure 1, Item 15). 5. Adjust two clamps (Figure 1, Item 6) and hose (Figure 1, Item 3) between turbocharger (Figure 1, Item 15) and air inlet housing (Figure 1, Item 7). Tighten clamps. 6. Torque nut (Figure 1, Item 2) on compressor housing coupling (Figure 1, Item 1) to 110–130 lb-in (12–15 N·m). 7. Adjust two clamps (Figure 1, Item 8) and hose (Figure 1, Item 10) between oil drain tube (Figure 1, Item 14) and elbow (Figure 1, Item 9). Tighten clamps. 8. On models 5063-5393 and 5063-539L, install insulation blanket (Figure 1, Item 4) on turbocharger (Figure 1, Item 15). Fasten blanket together using new wire (Figure 1, Item 5) and wire twister pliers as follows: a. Loop new wire around first capstan (Figure 2, Item 18) and apply two twists using wire twister pliers. b. While holding insulation blanket in place by hand, place ends of new wire on each side of adjacent capstan (Figure 2, Item 19) and apply at least two more twists using wire twister pliers. c. Trim new wire 3/4 inch (20 mm) from second capstan. d. Repeat Steps 10.a. – 10.c. for remaining pairs of capstans on blanket. 18 19 MAINT_095 Figure 2. Insulation Blanket Installation. END OF TASK END OF WORK PACKAGE TM 9-2815-205-24 0036 0036-3/blank