TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download

Page 230 of 856

REMOVAL 1. Cut wires (Figure 1, Item 1) on insulator set (Figure 1, Item 4). Remove insulator set from turbocharger (Figure 1, Item 7). Discard wires. 2. Loosen two clamps (Figure 1, Item 19) and hose (Figure 1, Item 20) at turbocharger air outlet. Slide clamps and hose onto air inlet housing (Figure 1, Item 18). NOTE If studs come loose from tee during removal of locknuts, replace studs (WP 0037). 3. Remove four locknuts (Figure 1, Item 8), four special washers (Figure 1, Item 9), and turbocharger (Figure 1, Item 7) from exhaust tee (Figure 1, Item 14). Discard locknuts. 4. Loosen compressor housing coupling (Figure 1, Item 23) and rotate outlet of compressor housing (Figure 1, Item 22) away from air inlet housing. CAUTION Tape all openings of turbocharger after removal from engine to keep foreign particles from entering and damaging turbocharger blades. 5. Remove two screws (Figure 1, Item 5), two lockwashers (Figure 1, Item 6), and turbocharger (Figure 1, Item 7) from air inlet housing (Figure 1, Item 18). Discard lockwashers. 6. Remove gasket (Figure 1, Item 17) from air inlet housing (Figure 1, Item 18) and gasket (Figure 1, Item 10) from exhaust tee (Figure 1, Item 14). Discard gaskets. 7. Remove two clamps (Figure 1, Item 19) and hose (Figure 1, Item 20) from air inlet housing (Figure 1, Item 18). 4 13 14 17 15 7 1 2 3 8 10 9 2 6 20 19 16 18 21 23 22 5 11 12 MAINT_093 Figure 1. Turbocharger Removal/Installation. END OF TASK TM 9-2815-205-24 0035 0035-2