TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 220 of 856
REMOVAL - Continued CAUTION Always install top of container on bottom of container (WP 0010) after the engine has been removed to avoid weather damage of container. NOTE Screw installed in the flywheel housing at eight o'clock position cannot be removed when the oil filter adapter is installed due to interference. 8. Remove four short screws (Figure 3, Item 25), two long screws (Figure 3, Item 22), two nuts (Figure 3, Item 26), six lockwashers (Figure 3, Item 24), and rear support (Figure 3, Item 7) from engine flywheel housing (Figure 3, Item 23). Store screws, washers, and nuts in mailbag (Figure 4, Item 9). Store mailbag and rear support in lower half of container (Figure 4, Item 13). Discard lockwashers. 22 24 26 24 24 23 7 25 26 MAINT_090 Figure 3. Engine Rear Support Removal. END OF TASK INSTALLATION WARNING Never crawl under equipment when performing maintenance unless equipment is securely blocked. Keep clear of equipment when it is being raised or lowered. Do not allow heavy components to swing while suspended by lifting device. Exercise caution when working near a cable or a chain under tension as equipment may drop or shift. Failure to comply may result in injury to personnel. 1. Attach beam-type sling (Figure 4, Item 1) to lifting brackets (Figure 4, Item 2) and support engine with lifting device. TM 9-2815-205-24 0033 0033-4