TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 214 of 856
INSTALLATION WARNING Never crawl under equipment when performing maintenance unless equipment is securely blocked. Keep clear of equipment when it is being raised or lowered. Do not allow heavy components to swing while suspended by lifting device. Exercise caution when working near a cable or a chain under tension as equipment may drop or shift. Failure to comply may result in injury to personnel. 1. Attach a beam-type sling (Figure 4, Item 1) to lifting brackets (Figure 4, Item 2) and support engine with lifting device. 2. Remove mailbag (Figure 3, Item 20) and engine support (Figure 3, Item 4) from bottom of container. Remove screws, washers, and nuts from mailbag. NOTE Use two flat washers (Figure 3, Item 22) between engine boss and engine support (Figure 3, Item 4) to mount engines with serial numbers up to 6D-16046 only. When not used, secure extra washers to support with locking wire or tape. 3. Install two screws (Figure 3, Item 17), four flat washers (Figure 3, Item 15), engine support (Figure 3, Item 4), and two nuts (Figure 3, Item 16) to rear of engine. 4. Install two screws (Figure 3, Item 14), four flat washers (Figure 3, Item 13), and two nuts (Figure 3, Item 21) in support at left side rear of engine. 5. Install two screws (Figure 3, Item 18) and two flat washers (Figure 3, Item 19) in support at right side rear of engine. 6. Torque two screws (Figure 3, Item 17) to 107–118 lb-ft (145–160 N·m). Torque two screws (Figure 3, Item 18) and (Figure 3, Item 14) to 22–24 lb-ft (30–33 N·m). TM 9-2815-205-24 0032 0032-4