TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 184 of 856
REMOVAL 1. Disconnect hose assembly (Figure 1, Item 1) from connector (Figure 1, Item 2) in top of turbocharger (Figure 1, Item 3). 2. Remove screw (Figure 1, Item 5) and lockwasher (Figure 1, Item 4) from clip (Figure 1, Item 7) on hose assembly (Figure 1, Item 1) at plate (Figure 1, Item 8) on rear of left cylinder head. Discard lockwasher. If necessary, remove clip (Figure 1, Item 7) from hose assembly (Figure 1, Item 1). 3. For model 5063-5392, remove screw (Figure 1, Item 12), flat washer (Figure 1, Item 16), lockwasher (Figure 1, Item 15), and nut (Figure 1, Item 14) from clip (Figure 1, Item 13) on hose assembly (Figure 1, Item 1) and from bracket (Figure 1, Item 17) on air inlet housing. Discard lockwasher. If necessary, remove clip (Figure 1, Item 13) from hose assembly (Figure 1, Item 1). 4. For models 5063-5393 and 5063-539L, remove screw (Figure 1, Item 11) and lockwasher (Figure 1, Item 10) from clip (Figure 1, Item 9) on hose assembly (Figure 1, Item 1) at left side of flywheel housing. Replace screw and lockwasher. If necessary, remove clip from hose assembly. 5. Disconnect hose assembly (Figure 1, Item 1) from oil filter adaptor (Figure 1, Item 6). Refer to (WP 0018) for model 5063-5392 or (WP 0019) for models 5063-5393 and 5063-539L. MODEL 5063-5392 MODELS 5063-5393 5063-539L 1 2 3 4 5 1 6 7 8 1 9 7 4 5 10 11 12 13 1 3 14 15 16 17 MAINT_075 Figure 1. Turbocharger Oil Supply Line Removal/Installation. END OF TASK TM 9-2815-205-24 0025 0025-2