TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 173 of 856
REMOVAL - Continued 8. Remove two short screws (Figure 2, Item 16), two lockwashers (Figure 2, Item 17), two flat washers (Figure 2, Item 18), two long screws (Figure 2, Item 21), two lockwashers (Figure 2, Item 20), two flat washers (Figure 2, Item 19), and filter mounting bracket (Figure 2, Item 10). Discard lockwashers. 16 17 18 19 20 21 10 MAINT_069 Figure 2. Fuel Filter Mounting Bracket Removal/Installation. END OF TASK INSTALLATION 1. Install filter mounting bracket (Figure 2, Item 10), two flat washers (Figure 2, Item 19), two new lockwashers (Figure 2, Item 20), two long screws (Figure 2, Item 21) (into side of flywheel housing), two flat washers (Figure 2, Item 18), two new lockwashers (Figure 2, Item 17), and two short screws (Figure 2, Item 16) (into top of flywheel housing). Torque screws (Figure 2, Item 21) to 71–75 lb-ft (96–102 N·m) and screws (Figure 2, Item 16) to 30–35 lb-ft (41–47 N·m). NOTE If two screws (Figure 1, Item 12) in upper section of fuel filter assembly have been removed, remove the lower canister to install screws due to interference (WP 0031). 2. Install two screws (Figure 1, Item 12), fuel filter assembly (Figure 1, Item 11), fuel strainer assembly (Figure 1, Item 9), two flat washers (Figure 1, Item 6), two new lockwashers (Figure 1, Item 7), and two nuts (Figure 1, Item 8) on filter mounting bracket (Figure 1, Item 10). Torque nuts to 30–35 lb-ft (41–47 N·m). 3. If removed, install two pipe plugs (Figure 1, Item 13), connector (Figure 1, Item 2), and tee (Figure 1, Item 14) on fuel filter assembly (Figure 1, Item 11). 4. If removed, install pipe plug (Figure 1, Item 15) in tee (Figure 1, Item 14) on fuel filter assembly (Figure 1, Item 11). TM 9-2815-205-24 0023 0023-3